#Cost to paint 2 car garage door plus#

Use a medium grade sandpaper to smooth out the surface and get rid of any rust spots if you have a metal door. The next step is to give the complete door a sand. Sand down the filler with 120 grit sandpaper and a lighter 150-180 grit to blend the edges. Now fill with a suitable exterior filler - Big Boy Metal Filler (opens in new tab) is a good choice. A 80-120 grit sandpaper is good for this. If you have a dent in a metal door, first sand with the area for extra adhesion. If you have a wooden door, use an appropriate exterior filler - Everbuild High Performance Wood Filler (opens in new tab) is a good choice and it sets rock hard. If your door has flaking paint or rust spots, use a paint scraper to remove the worst of it. Step 2: Fill and Sand Any Cracks or Dents This is to help ensure that no dirt or dust on the ground gets on your wet paint. Don’t forget to include the frame if you are going to paint this.Īlso, sweep around the area by the bottom of the garage door. First, brush over the door to remove any dirt, dust and cobwebs. But, if unsure, do not remove it.īefore any paint is put on your garage door, it needs to be cleaned. Typically you won't, but if your door is easy to remove - and you don't need it for security reasons - it can be an option. Clean the Areaīefore you start cleaning, decide if you need to remove your garage door to get the finish you want. (Image credit: Direct Doors) Preparation Step 1.

Masking tape (opens in new tab) or painters tapeĬhoosing the Right Paint for Painting a Garage Door.You Will Need Essential Tools for Painting a Garage Door So expect to pay around £120+ for a single door with little or no prep needed, and around £200+ for a single garage door with prep and a primer and two coats.

#Cost to paint 2 car garage door plus#

The pros charge around £15-20 an hour plus paint. Paint for a single garage door with a primer and two coats would cost you around £50, plus any materials if needed, totalling approximately £70. You will need approximately 0.5 litre for one coat of paint on a single door and 1 litre for a double door. The cost will vary depending on the size of the door and if you need to purchase any gear such as brushes and rollers etc.Ī typical single garage door is 6ft 6in x 7ft (approximately 45 sq ft), and a double door will be around 14 ft x 7ft (approximately 98 sq ft). Spray all the way around and windows, then start at the top and work your way down.How Much Does Painting a Garage Door Cost? At the edges of the house, use a spray shield to help control overspray.

To achieve the best spray pattern, always start at the lowest pressure and increase, until you achieve the desired results.

Spraying horizontally, work in sections only as far as you can comfortably reach.

Fanning the sprayer one-way or the other will result in uneven spray patterns.

Flex your wrist so the front of the sprayer remains perpendicular to the surface.

Aim at the middle of each previous pass so you’ll overlap it by 50%.

This will create a fuzzy edge around the entire spray pattern to help create an even finish.

The gun must be moving when the trigger is pulled and released.

Pull the gun trigger after starting each stroke, then release the trigger before the end of each stroke.

Hold the spray tip approximately 12 inches from the surface.

This is where you can fine-tune your technique and adjust the sprayer for the best spray pattern:

If you don’t have a lot of spraying experience, practice spraying on a piece of cardboard.If you’re using paint from multiple containers, mix it together in an empty 5-gallon container to ensure consistent color even if small color differences exist between individual paint cans. Pour your paint through a strainer, to get rid of any dried sediment.

Be sure the tip’s hole size does not exceed the maximum capacity of your sprayer (see spray tip info).

Select the spray tip that’s best suited for the paint you are using and the surface to be sprayed.